From civil standard to vehicle gauge level
from the automotive industrySAFELAUNCH science and technology system
Safety-oriented, although the most basic value of all child safety seat brands is to provide baby driving protection,
But lasting reliability, need to abandon the gorgeous advertising and publicity, with the core of the enterprise bottom ability and quality management ability, bear the basic responsibility of safety.
Maple & Co. child safety seats comprehensively learn from the automotive industry’s century-old safety gene precipitation,
With professional product development logic in the automotive industry, manufacturing management system, PPM quality standards (close to 0 defects, less than a million defective rate),
Strive to realize the Safe Launch (safe mass production) that the automobile industry is committed to, and provide mothers with a sense of peace of mind beyond the function itself.
PDP Product Development Process
360 degree quality management
Maple & Co. child safety seats are consumer-oriented, expanding product life cycle process management, emphasizing process control, quality management and waste reduction. Use product advanced quality planning (APQP), potential failure mode and consequence analysis (FMEA), statistical process control (SPC) and error-proofing (POKA-YOKE) methods to prevent defects, focus on process stability, and promote the effectiveness of the enterprise’s quality management system through continuous improvement methods, full participation and employee motivation.
Platform, Modularization, Standardization
Research and development logic, strengthen the security foundation
Platformization, modularization and standardization are the basic logic of product development in the automotive industry. This is not only to improve development efficiency and correspond to the needs of flexible production lines, but also because each module has undergone years of multi-dimensional quality verification to ensure the rigor of product design and quality stability.
Maple & Co. pays special attention to product safety and comfort in product research and development. In the design goal, DVP(Design Verification Plan) is clearly defined to ensure safety, comfort evaluation and exquisite process evaluation standards. FEA simulation simulation and verification are continuously carried out during the design process, thus passing the European regulation ECE R129 (i-Size) at one time and obtaining 13 patents.
Manufacturing Management System
Extreme to eliminate human error
Maple & Co. child safety seats are consumer-oriented, expanding product life cycle process management, emphasizing process control, quality management and waste reduction. Use product advanced quality planning (APQP), potential failure mode and consequence analysis (FMEA), statistical process control (SPC) and error-proofing (POKA-YOKE) methods to prevent defects, focus on process stability, and promote the effectiveness of the enterprise’s quality management system through continuous improvement methods, full participation and employee motivation.
Parts Per Million
Maple & Co. strictly follows the requirements of the quality system of the automobile industry, intervenes from the beginning of product development and uses APQP (Advanced Product Quality Planning) to carry out quality management. At the same time, it sets strict material selection standards for parts and components, takes the standards of prohibited and restricted substances and VOC as the basic red line, and uses SPC and MSA to fully analyze and control defects in the manufacturing process, to achieve a defect rate below the million-point standard.
Copyright maple.&co. All Rights Reserved. |Shanghai ICP No. 2023008353| Shanghai Public Network Anbei 11010802024835
本网站由阿里云提供云计算及安全服务 | Powered by HAP AGENCY
